Home › Glossary › Roof Flashing
Roofing term
Roof Flashing
Definition: Roof flashing is thin metal or other waterproof material installed where a roof meets a wall, chimney, skylight, vent or valley to direct water away from the joint.
What is Roof Flashing?
Roof flashing is a thin piece of metal or other waterproof material that seals the joints on a roof. It is used where a roof meets a wall or chimney, where two roof planes meet in a valley, and around skylights, vents and other openings. Flashing sends water back onto the roof surface instead of into the joint.
Step flashing, counter flashing and valley flashing are a few common types.
Why it matters
Most roof leaks start at a joint rather than in the open field of shingles. Worn, loose or missing flashing around chimneys, walls and vents is a common reason for a roof repair, and reusing old flashing on a new roof can bring the same leak back.
Shingles shed water well across the open roof, but joints and penetrations are where leaks usually start. Flashing that is reused, rusted or nailed wrong can let water into the walls and ceilings.
What the building code requires
The International Residential Code, which Maryland’s building code is based on, includes these rules:
- Flashing is required where roofs meet walls, where the slope or direction changes and around roof openings.
- Metal flashing must be corrosion resistant and at least 0.019 inch thick (No. 26 galvanized sheet).
- A cricket or saddle is required on the high side of a chimney or penetration wider than 30 inches.
- Base flashing where a roof meets a sidewall must be at least 4 by 4 inches, continuous or step, with the vertical leg under the siding.
Common flashing problems
- Sealant used in place of real flashing.
- Old flashing reused on a new roof.
- Rust or holes in metal flashing.
- Siding installed over flashing the wrong way.
Flashing during a roof replacement
Ask your roofer which flashing will be replaced and how chimney and wall joints will be handled. The IRC says other flashing details must follow the shingle manufacturer’s instructions.
Learn more
These pages cover related roof and siding topics.
Related Heward services
Frequently asked questions
Where is roof flashing required?
The IRC requires flashing where roofs meet walls, at changes in slope or direction and around roof openings.
What is a chimney cricket?
A cricket, or saddle, is a small peaked structure on the high side of a chimney that sends water around it. The IRC requires one for chimneys or penetrations wider than 30 inches.
Should flashing be replaced with a new roof?
Old or damaged flashing is often replaced so it does not become the weak point of a new roof.
Have a question about your project?
Ask about your roof, siding, windows or interior project: Contact Heward Home Improvement.
